Sony DCR-VX1000 - Manual (Page 25)

25
Advanced Operations
LOCK
STANDBY
PHOTO STANDBY
START/
STOP
EDITSEARCH EDITSEARCH
LOCK
STANDBY
PHOTO STANDBY
START/
STOP ZERO SET
MEMORY
3
2
1
4
5
[b] [a]
Re-recording a Picture in the Middle of a
Recorded Tape
You can re-record a scene in the middle of a recorded tape by setting the starting [a] and ending [b]
points.
The previously recorded portion will be erased.
(1) Press START/STOP while recording.
The camcorder enters Standby mode.
(2) Hold down the +(forward) or –(reverse) side of EDITSEARCH until the camcorder goes to the
point where you want to end the insertion. [b]
The camcorder enters Standby mode again.
(3) Press ZERO SET MEMORY.
The counter is reset to “0:00:00”.
“ZERO SET MEMORY” flashes, and the ending point is stored in memory.
(4) Hold down the – side of EDITSEARCH until the camcorder goes back to the point where you want
to start the insertion. [a]
The camcorder enters Standby mode again.
(5) Press START/STOP to start re-recording.
The insert recording stops automatically at the counter zero point, and the camcorder enters Standby
mode again. Zero set memory resumes automatically.
To change the end point
Press ZERO SET MEMORY so that “ZERO SET MEMORY” disappears.
Repeat steps 2 to 4.