Sony DCR-VX1000 User Manual

Page 67

Advertising
background image

67

Additional Information

Precautions

Camcorder Operation

• Operate the camcorder using 7.2 V (battery pack), or 8.4 V (AC power adaptor).
• For DC or AC operation, use only the accessories recommended in this manual.
• Should any solid object or liquid fall into the casing, unplug the camcorder and have it checked by

your nearest Sony dealer before operating it any further.

• Avoid rough handling or mechanical shock. Be particularly careful of the lens.
• Keep the POWER switch set to OFF when not using the camera.
• Do not wrap up the camcorder and operate it since heat may build up internally.
• Keep the camcorder away from strong magnetic fields or mechanical vibration.

On Handling Tapes

• Do not insert anything into the small holes on the cassette.
• Do not open the tape protect cover or touch the tape.
• Avoid touching or damaging the terminals. To remove dust, clean the terminals with a soft cloth.

Camcorder Care

• When the camcorder is not to be used for a long time, disconnect the power source and remove the

cassette. Periodically turn on the power, operate the CAMERA and VTR sections and play back a
tape for about 3 minutes.

• Clean the camcorder body with a soft dry cloth, or a soft cloth lightly moistened with a mild

detergent solution. Do not use any type of solvent which may damage the finish.

AC Power Adaptor

Charging
• Use only a lithium ion type battery.
• Charge the battery on a flat place without vibration.
• The battery will get hot during charging. However, this is normal.

Others
• Unplug the unit from the wall outlet when not in use for a long time. To disconnect the cord, pull it

out by the plug. Never pull the cord itself.

• Do not operate the unit with a damaged cord or if the unit has been dropped or damaged.
• Do not bend the AC power cord forcibly, or put a heavy object on it. This will damage the cord and

may cause a fire or an electrical shock.

• Be sure that nothing metallic comes into contact with the metal parts of the connecting plate. If this

happens, a short may occur and the unit may be damaged.

• Always keep the metal contacts clean.
• Do not disassemble the unit.
• Do not apply mechanical shock or drop the unit.
• While the unit is in use, particularly during charging, keep it away from AM receivers and video

equipment because it will disturb AM reception and video operation.

• The unit becomes warm while in use. This is normal.
• Do not place the unit in locations that are:

– Extremely hot or cold
– Dusty or dirty
– Very humid
– Vibrating

If any difficulty should arise, unplug the unit and contact your nearest Sony dealer.

Advertising