Sony D-NE920 - Manual (Page 36)

Symptom Cause and/or corrective action
Playback starts from the point you
stopped (resume function).
 The resume function is working. To start play from the first
track, press  on the remote while the player is stopped (on
the player, press and hold  on the jog lever) until the first
track starts playing, or open the lid of the player (  page 17).
Or, remove all power sources, and then insert the battery or
connect the AC power adaptor again.
During playback of an ATRAC
CD or MP3 CD, the CD does not
rotate but you can hear the sound
normally.
 This player is designed to stop the rotation of an ATRAC CD
or MP3 CD during playback to reduce the power consumption.
The player is not malfunctioning.
“No File” appears on the display
after you press  on the remote
(on the player, after you press 
on the jog lever) or when the lid of
the player is closed.
 There are no ATRAC3plus/MP3 files on the CD-R/CD-RW.
 A CD-R/CD-RW from which the data has been erased is being
used.
 The CD is dirty.
The LCD display becomes hard to
see or slows down.
 You are using your CD player at high temperatures (above
40°C/104°F) or at low temperatures (below 0°C/32°F). At
room temperature, the display will return to its normal
operating condition.
is flashing quickly on the
display of the remote control, and
you cannot locate the beginning
of the track or a specific point in
the track.
 The CD player has entered the preparation stage of Bookmark
play. Change the PLAY MODE setting to “ALL” (  page 23).
Even though you have not selected
“BOOKMARK,” (Bookmark)
flashes.
 If you have selected a playback option other than
“BOOKMARK,” (Bookmark) flashes.
Play stopped abruptly.  The off timer has been set. Change the setting of “TIMER” to
“OFF” (  page 31).
 The rechargeable battery or the dry battery is used up
completely. Charge the rechargeable battery (  page 11),
or replace the dry battery with a new LR6 (size AA) alkaline
battery (
 page 13).
You cannot operate the player, and
a sequence of 8 numbers or letters
appear on the display of the CD
player and the remote.
 This phenomenon may occur, depending on the CD you are
using. Remove all power sources, and then insert the battery
or reconnect the AC power adaptor. Try to operate the player
again. If the problem persists, consult your nearest Sony dealer.
36
D-NE920/NE920LS.GB.2-318-333-21(1)