Sony STR-DE685 - Manual (Page 4)

4
GB
4-XXX-XXX-XX AA
VIDEO SPEAKERS IMPEDANCE USE 8 – 16 Ω
Y
P B B-Y
P R R-Y
NITOR OUT
R L
EAKERS IMPEDANCE USE 8 – 16 Ω
FRONT A CENTER
AC OUTLET
FRONT B
R L
R L
Area code
About This Manual
The instructions in this manual are for model
STR-DE685. Check your model number by looking at
the lower right corner of the front panel.
About area codes
The area code of the receiver you purchased is
shown on the lower portion of the rear panel (see
the illustration below).
Any differences in operation, according to the
area code, are clearly indicated in the text, for
example, “Models of area code AA only”.
Tip
The instructions in this manual describe the controls
on the receiver. You can also use the controls on the
supplied remote if they have the same or similar
names as those on the receiver. For details on the use
of your remote, see
• pages 42–48 for RM–PP411 (models of area code
U, CA only).
• pages 49–52 for RM–U305C (except for models of
area code U, CA)
Note for the supplied remote
For RM-PP411 (Models of area code
U, CA only)
The TV/SAT, PHONO, SOURCE, MPX/
DUAL, ANALOG DIRECT, 12 and
ON SCREEN buttons on the remote are not
available.
For RM-U305C (Except for models of
area code U, CA)
The TV/SAT and PHONO buttons on the
remote are not available.
Demonstration Mode
The demonstration will activate the first time you
turn on the power. When the demonstration starts,
the following message appears in the display:
“NOW DEMONSTRATION MODE IF
YOU FINISH DEMONSTRATION
PLEASE PRESS POWER KEY WHILE
THIS MESSAGE APPEARS IN THE
DISPLAY THANK YOU”
To cancel the demonstration
Press ?/1 to turn the receiver off while the above
message is being displayed. The next time you
turn the receiver on, the demonstration will not
appear.
To view the demonstration
Hold down SET UP and press ?/1 to turn on the
power.
Notes
• Running the demonstration will clear the
receiver’s memory. For details on what will be
cleared, see “Clearing the receiver's memory”
on page 17.
• There will be no sound when the demonstration
mode is activated.
• You cannot cancel demonstration if you did not
press ?/1 while the above message is being
displayed. To cancel demonstration after the
above message appears, press ?/1 twice to
activate the demonstration again. Then, press
?/1 while the above message is being
displayed.