Sony FWD-S42E1 - Manual (Page 57)

17 GB
GB
Optional Adaptors
The terminal of the OPTION slot qh (page 12) on the
side of the equipment is a slot-in type. It can be
switched to the following optional adaptors (not
supplied).
For details on installation, consult your Sony dealers.
For details on the optional adaptors for system
expansion, see each instruction manual with this
manual.
COMPONENT/RGB INPUT Adaptor BKM-
FW11
1 Y/G, P
B
/C
B
/B, P
R
/C
R
/R IN connector (BNC):
Connects to the analog RGB signal or component
signal output of a piece of video equipment or PC.
2 HD, VD IN connector (BNC): Connects to the
synchronization signal output of a PC.
When inputting a component signal, be sure not to input sync
signals to the HD and VD connectors. If you do so, the
picture may not be displayed properly.
3 AUDIO jack (Stereo mini jack): Connects to the
audio output of a piece of video equipment or PC.
HDMI INPUT Adaptor BKM-FW15
Connects to the HDMI signal output of a piece of
video equipment or PC. You can enjoy enhanced or
high-definition video, and two-channel digital audio.
• Be sure to use only an HDMI cable (not supplied) that
bears the HDMI logo. We recommend that you use a Sony
HDMI cable (high speed type).
• HDMI control is supported by serial numbers 7000001
onwards.
HD-SDI/SDI INPUT Adaptor BKM-FW16
Connects to the HD-SDI signal output of a piece of
video equipment.
MONITOR CONTROL Adaptor BKM-FW21
1 CONTROL S IN/OUT jack (Mini jack): You
can control pieces of multiple equipment with a
single remote control when the display is
connected to the CONTROL S jack of the video
equipment or another display.
2 REMOTE connector (D-sub 9-pin): You can
remote control of the display using the RS-232C
protocol. For details, contact your authorized
Sony dealers.
You cannot use the REMOTE connector of another display
if connected to this display. Use the REMOTE connector of
this display.
NETWORK MANAGEMENT Adaptor BKM-
FW32
You can connect this device to the network with a
LAN cable (10BASE-T/100BASE-TX).
You can assign various settings and control the
display via the network from a PC.
For safety, do not connect the connector for peripheral device
wiring that might have excessive voltage to this port. For this
port, follow the instruction manual of the optional adaptor.
Note
Notes
Note
Caution