Sony FWD-S42E1 - Manual (Page 66)

26 GB
Setup Settings
For how to select and change settings, see the section of “Overview of the Menus” (page 21).
Menu Function and operation
Language Select from the language settings shown. Select “English”, “Français”, “Deutsch”,
“Español”, “Italiano” or “
”.
Timer Setting You can adjust time, display the built-in clock, or set the timer to make the display
power on/off at a predetermined time.
If the built-in clock tends to lose time, the internal battery may be exhausted. Please
contact your authorized Sony dealer to have the battery replaced.
Clock Set Sets the day of the week and the hour of the day.
Date Set Sets the date (year, month, date). The day is automatically set.
Time Set Sets the time.
Clock Display Select “On” or “Off”. If you select “On”, when the remote control’s DISPLAY
button is pressed, it shows the current time which was set.
On/Off Timer Sets the day of the week and the hour of the day.
This cannot be used unless the “Timer Setting” has been set.
ECO Mode Changes the backlight brightness, reducing energy conservation. Higher settings
save less energy.
Off/Low/High
Status Display Select “On” or “Off”. If you select “On”, the input signal and “Aspect” information
show on the screen for about 5 seconds when the display is turned on. When you
switch the input signal, the input signal information shows for about 5 seconds.
Tip
You can display the input signal and “Aspect” information by using DISPLAY
button on the remote control.
Speaker Out Select “On” or “Off”. If you select “On”, sound is output from the speakers.
Advanced Setup Enter more detailed settings.
Control Setting This menu is used for settings of operation of the display and the remote control.
Index Number You can change the index number of the display if necessary. Select to set the index
number of the display with
F/f buttons on the display, and press button to
confirm the setting.
The “Index Number” cannot be set with the remote control.
Control Mode Set to control the display from the remote control or from the display.
When this item is operated, the available modes will differ depending on whether
you select by the remote control or the display. When setting this item with
button on the remote control, you can select only “Display+Remote” or “Remote
Only”. When setting this item with button on the display, you can select only
“Display+Remote” or “Display Only”.
Display+Remote Enables operation of the display with the control buttons on the display and the
remote control.
Note
Note
Note
Note