Sony MHC-V5 - Manual (Page 46)

MHC-V5.GB.4-531-350- 11(2)
46 GB
NOT IN USE
You tried to perform a specific
operation under conditions where
that operation is prohibited.
NOT SUPPORTED
An unsupported USB device is
connected, or the USB device is
connected through a USB hub.
PROTECT
The USB device is write-protected.
PUSH STOP
You tried to perform an operation
that can be performed only when
the playback is stopped.
READING
The system is reading information
of the disc or USB device. Some
operations are not available.
REC ERROR
The transfer did not start, stopped
partway, or otherwise could not be
performed.
STEP FULL
You tried to program more than 25
steps.
TIME NG
The on time and off time of Play
Timer or Recording Timer is the
same.
TRACK FULL
You cannot transfer onto the USB
device because the number of file
has reached its maximum.
Precautions
When carrying this system
To avoid damaging the disc
mechanism, perform the following
procedure before carrying this
system.
Use the buttons on the unit to
perform this operation.
1
Press  to turn on the system.
2
Press CD.
3
Remove the disc.
Press  to open and close the disc
tray.
Wait until “NO DISC” appears on the
display.
4
Unplug the AC power cord.
Notes on discs
ˎ ˎ Before playing, wipe the disc with a
cleaning cloth from the center outward
to the edge.
ˎ ˎ Do not clean discs with solvents, such
as benzine, thinner, or commercially
available cleaners or anti-static spray
intended for vinyl LPs.
ˎ ˎ
Do not expose discs to direct sunlight
or heat sources such as hot air ducts,
nor leave them in a car parked in direct
sunlight.
On safety
ˎ ˎ Completely disconnect the AC power
cord (mains lead) from the wall outlet
(mains) if it is not going to be used
for an extended period of time. When
unplugging the unit, always grip the
plug. Never pull the cord itself.
ˎ ˎ
Should any solid object or liquid get
into the system, unplug the system, and
have it checked by qualified personnel
before operating it again.