Sony KLV-40ZX1M - Manual (Page 7)

7 US
G
e
tting Started
This model is ready to be mounted on a wall. For
details, see page 22.
• For product protection and safety reasons,
Sony strongly recommends that you use the
Wall-Mount Bracket model designed for your
LCD monitor and the wall-mounting of LCD
monitor should be performed by a Sony
dealer or licensed contractor.
• Sufficient expertise is required in installing this
LCD monitor, especially to determine the
strength of the wall for withstanding the LCD
monitor’s weight.
• Be sure to use the screws supplied with the Wall-
Mount Bracket when attaching the mounting
hooks to the LCD monitor.
The supplied screws are designed so that they are
8 mm to 12 mm in length when measured from
the attaching surface of the spacer.
The diameter and length of the screws differ
depending on the Wall-Mount Bracket model.
Use of screws other than those supplied may
result in internal damage to the LCD monitor set
or cause it to fall, etc.
• Be sure to store the unused screws and Table-Top
Stand in a safe place until you are ready to attach
the Table-Top Stand. Keep the screws away from
small children.
For details on how to use the Wall-Mount Bracket
compatible to your model, visit
www.sony.com/accessories
Or call 1-800-488-7669 (for United States)
1-877-899-7669 (for Canada)
Make sure that your LCD Monitor has adequate
air circulation. Allow enough space around the
unit as shown below. Avoid operating the unit at
temperatures below 41 °F (5 °C).
~
• Inadequate air circulation can lead to overheating of
the unit and may cause damage to your unit or cause a
fire.
Consider the following for best picture
quality
• Do not expose the screen to direct illumination
or sunlight.
• Use spot lighting directed down from the
ceiling or cover the windows that face the
screen with opaque drapery.
• Install the unit in a room where the floor and
walls are not of a reflective material.
Preparation for Wall-Mount Bracket
8-12 mm
Screw M6 × 16 (supplied with the
Wall-Mount Bracket)
Mounting Hook
Rear of the LCD monitor
Spacer (black)
When attaching to the Wall-Mount Bracket
8-12 mm
Screw M6 × 20 (supplied with the
LCD monitor)
Mounting Hook
Rear of the LCD monitor
Spacer (silver)
When attaching to the Floor Stand
When Installing the Unit Against a
Wall or Enclosed Area
(30 cm)
11 7 /
8 inches
4 inches
(10 cm)
4 inches
(10 cm)
(6 cm)
inches 2 3 /
8
Leave at least this much space around the set.
Installed with stand
inches 11 7 /
8
4 inches
(10 cm) 4 inches
(10 cm)
4 inches (10 cm)
(30 cm)
Installed on the wall
Leave at least
this much space
around the set.
Never install the unit set as follows:
Air circulation is blocked. Air circulation is blocked.
Wall
Wall
(Continued)