Sony MZ-R90 - Manual (Page 19)

19
5
While observing the level meter in the
display, adjust the recording level by
flipping the jog lever or pressing >
(+) or . (–).
Set the level so that the level meter
reaches around
(–12 dB) mark
beneath the display window.
If the sound is too high, lower the
recording level until the level meter
just barely reaches the
(OVER)
mark beneath the display window.
Recording doesn’t start in this step.
If your source is an externally
connected component, be sure to cue
the source to the beginning of the
material to be recorded before you
start playback.
6
Press X again to start recording.
To stop recording, press x.
The recording level control is switched back to
automatic control when you record the next
time.
Notes
• The recording level cannot be adjusted while
recording is in progress. If you want to adjust
the recording level after you have started the
recording, press X to pause the recorder. Then
do the procedure from step 5.
• You cannot adjust the recording level
manually during synchro-recording.
Checking the remaining
time or the recording
position
You can check the remaining time, track
number, etc. when recording or during
stop.
On the recorder
1
While the recorder is recording or
stopped, press the jog lever, flip until
“DISPLAY” flashes in the display,
and then press the lever again.
2
Flip the jog lever until the
information you want flashes in the
display.
Each time you flip the lever, the
display changes as follows.
Display window on the recorder
While recording
REC +
< ,
Volume decreases increases
–12 dB OVER
A B 1)
1) Display order
C 2)
LapTime 1 3
RecRemain 2 3
Clock 3 3
Jog lever
REC indicator
A
B
C
continued