Apple Logic Board User Manual
Page 13
Xserve Logic Board -
13
Power Supply
1.
Reconnect the power supply to the logic board.
2.
Tighten the thumb screw that secures the power supply to the chassis.
3.
Reconnect the power supply cable to the drive interconnect board.
ATA Controller Board
1.
Reconnect the ATA controller board to the drive interconnect and logic boards.
Note:
When replacing the ATA controller board, align it over the two pairs of
connectors on the drive interconnect and logic boards, making sure the “MLB” arrow
printed on it points toward the logic board, and press down.
(Figure 16)
Figure 16
2.
Reinstall the two ATA controller clips.
Note:
When replacing the ATA controller board clips, orient them so that the long end
of each clip points away from the middle of the server. Place the inside edge of the
clip into the small notch and then snap down the outer edge of the clip.
(Figure 17)
Figure 17