Panasonic TYST20K - Manual (Page 11)

11
Assembly Procedure
(Cont’d)
2. Install the Plasma Display
Place the assembled pedestal with the rear side (side with the model nameplate attached) facing towards
yourself, align the plasma display with the stand poles, insert the stand poles into the plasma display, and insert
and tighten the unit installation screws
(4 screws).
(Tightening torque: 1.5 to 1.8 N•m)
3. Connecting Additional Equipment and the Power Cord
● For details on wiring connections, see the instruction manual of the plasma display.
● Connect the necessary wiring for the additional equipment, pass a clamper
(1 clamper) through the clip on the
rear of the stand base, and bunch together all of the cords and cables as shown in the diagram.
● Do not bunch the power cord together with other cords and cables.
Rear View
While ensuring there is sufficient slack in the cord to minimize stress,
firmly bind cables with the supplied clamper
.
Binding the Cables
Pass the tip of the clamper
through the clip
Pull
Bundle
all cables
tidily
Unbinding the Cables
Pull
Pull the lock
section of the
clamper
Clamper
Cables
Clip
Unit installation screw Model Nameplate
With the side that has the model nameplate
attached facing you, insert the stand poles as
far as possible into the plasma display.
Rear of Plasma Display Rear of Plasma Display
English