Panasonic TYST20K - Manual (Page 12)

12
Assembly Procedure
(Cont’d)
4. Plasma Display Overturn-Prevention
● Anchor the plasma display to both the base and the wall surface.
Anchoring to the base
Attach the overturn-prevention belts (2 belts) to the pedestal using screws (2 screws) through the
screw holes at both sides of the rear of the pedestal, and use the wood screws (2 screws) to anchor to the
base.
When attaching to the base, insert the wood screws into the prepared holes.
If there are no prepared holes, drill new holes to the center of the base board width.
(Screw
tightening torque: 1.2 to 1.5 N•m)
Anchoring to the wall
Pass sturdy string, wire, or other such
commercially available item through the
holes at both sides of the rear of the
pedestal, and anchor the string etc. to a
secure wall or pillar.
Screw
Screw
Overturn-prevention belt
Overturn-prevention
belt
Front face
Wood screw
Wood
screw
Locate the wood screw at
the center of the material
width.
[For safety reasons, always use the overturn/fall prevention accessories]
The equipment may overturn in the event of an earthquake etc. Therefore, always use the overturn/fall
prevention accessories.
※ The details in this section indicate how to reduce any damage or injury caused by this equipment
overturning or falling due to an earthquake. However, there is no guarantee that the overturn/fall
prevention accessories will be effective in all earthquake situations.
Surface of wall
English