Panasonic TYST20K - Manual (Page 9)

9
WARNING
Do not disassemble or modify the pedestal.
• Doing so may cause the unit to fall over and become damaged, which may result in personal injury.
CAUTION
Do not use any plasma displays other than those given in the catalogue.
• Doing so may cause the unit to fall over and become damaged, which may result in personal injury.
Do not climb on or hang from the pedestal or attached equipment.
• Doing so may cause the unit to fall over and become damaged, which may result in personal injury. (Be particularly
careful that young children obey this caution.)
Do not use the pedestal if it has become bent or deformed for any reason.
• Doing so may cause the unit to fall over and become damaged, which may result in personal injury.
Do not block the ventilation holes. When using the pedestal, do not block the space between the bottom
surface of the plasma display and the floor surface.
• Otherwise heat may build up inside and cause a fire.
Do not use in places with high humidity.
• After prolonged use, the pedestal may warp or become deformed, reducing its strength. This may lead to the unit
falling over and becoming damaged, which may also result in personal injury.
When installing the plasma display, ensure there is at least a 10 cm (3.9 inches) space above and to the
sides of, and a 7 cm (2.8 inches) space to the rear of the plasma display.
• Failing to do so may result in a fire.
Two people are required to install and remove the display from the pedestal.
• The plasma display may fall and cause injury.
During setting-up, make sure that all screws are securely tightened.
• If assembly is not performed correctly, the pedestal will not be able to support the weight of the display. This may
result in the display falling over and becoming damaged, which may result in personal injury.
For installation, use the special-purpose constituent parts.
• Otherwise, the plasma display may fall off the wall and/or be damaged, possibly causing injury.
Set up on a stable, level surface.
• Failure to do so may cause the unit to fall over and become damaged, which may result in personal injury.
Keep the unit away from direct sunlight and heating equipment.
• Failure to do so may cause warping, deformation, or degradation of materials which may result in a loss of strength
that may cause the equipment to fall over or break and cause injury.
Use the overturn/fall-prevention accessory to secure the Plasma Display.
• If an earthquake occurs or children climb onto the pedestal with the Plasma Display installed, the unit may overturn
or fall over, resulting in personal injury.
Notes on installing the pedestal
♦ For the plasma display power supply plug, use a power supply outlet that can be reached easily.
♦ Ensure good air flow so that the ambient temperature does not exceed 40 °C (104 °F).
Failure to do this may cause heat to build up inside the plasma display, resulting in malfunction.
Requests regarding handling
1) Exercise care when selecting the location for the plasma display because it may discolor or deform due to
light or heat if it is placed where it is exposed to direct sunlight, or near a heater.
2) Clean the pedestal by wiping it with a soft, dry cloth (such as cotton or flannel). If the bracket is very dirty,
remove the dirt using a neutral detergent diluted in water, and then wipe it clean with a dry cloth. Do not use
benzene, thinner, or furniture wax as this may cause the coating to peel.
(For information on cleaning the plasma display, see the plasma display’s instruction manual. If using a
chemically-treated cloth, follow the instructions supplied with the cloth.)
3) Do not affix adhesive tape or stickers to the product. Doing so may dirty the surface of the pedestal. Do not
allow long-term contact with rubber, vinyl products or the like. (Doing so will cause deterioration.)
4) The panel of the plasma display is glass. Do not subject it to a strong force or impact.
Caution:
This pedestal is intended for only Panasonic plasma display models (See page 57).
Use with other apparatus is capable of resulting in instability causing possible injury.
PROFESSIONAL INSTALLATION IS REQUIRED.
PANASONIC DISCLAIMS ANY PROPERTY DAMAGE AND/OR SERIOUS INJURY, INCLUDING DEATH
RESULTING FROM IMPROPER INSTALLATION OR INCORRECT HANDLING.
English
Safety precautions
English