Avaya 3.7 - Manual (Page 171)

Firewall rules set up
Issue 4 May 2005 171
5. Select Template, Device, or None.
6. Click Apply.
7. To create a user-defined firewall template, type in a name for your new firewall template,
otherwise click Cancel.
8. Confirm that the correct user-defined firewall template is selected in the Contents column.
9. Click Add to open the Firewall Policy wizard.
10. Type a name for the new rule in the Name text box.
11. Select Enabled or Disabled in the Status drop-down list to enable or disable the new rule.
12. Select Permit or Deny in the Action drop-down list to control the flow of packets for this rule.
13. Permit allows all packets of the selected traffic type to pass.
14. Deny blocks all packets of the selected traffic type.
15. Click Next.
16. Select the set of sources from the available source list.
17. Click Next.
18. Select the set of destinations from the available destination list.
19. Click Next.
20. Select the set of services from the available services list.
21. Select the Interface from the drop-down list.
Parameter Description
Template The user-defined template is created
using a predefined template – high,
medium, or low. Select the template
from the drop-down list.
Device The user-defined template is created
using an existing security gateway
firewall configuration. Select the
existing security gateway from the
drop-down list. Using an existing
security gateway configuration is also
know as cloning the configuration.
None The user-defined template is created
without using a predefined template or
an existing security gateway firewall
configuration.