Panasonic KXTG7873 - Manual (Page 54)

Pairing a headset to the base unit
Important:
R Make sure that the Bluetooth headset is not
connected to any other Bluetooth device.
1
Your headset:
Set your headset to pairing mode.
R Refer to the headset operating
instructions.
2
Handset:
MMENUN#621
3
If your headset PIN is “0000”, go to
step 4.
If your headset PIN is other than
“0000”, press MCLEARN, then enter your
headset PIN.
R Typically, default PIN is “0000”. Refer
to the headset operating instructions.
4 Press MOKN, then wait until a long beep
sounds.
5
MOFFN
R When
is displayed on the base
unit, the headset is available for use.
Connecting/disconnecting a headset
If you cannot connect the headset and base
unit using the headset, you can connect using
the unit.
To use your headset with another Bluetooth
device such as a cellular phone, you may
need to disconnect it from the base unit.
Important:
R Make sure that the headset is turned on.
Handset / Base unit
1
To connect/disconnect:
MMENUN#622
R A long beep sounds.
2
Proceed with the operation for your unit.
Handset: MOFFN
Base unit: MEXITN
Unpairing a headset
You can cancel a pairing of the headset that is
stored to the base unit.
Handset
1
MMENUN#612
2
MbN: “Yes” a MSELECTN
R When the headset is unpaired, the
disappears from the base unit
display.
3 MOFFN
Operating a Bluetooth wireless
headset using a landline
Important:
R Refer to your headset operating instructions
for headset operations.
Answering landline calls with your
headset
To answer a landline call, turn on your
headset referring to your headset operating
instructions.
When you finish talking, turn off your headset
referring to your headset operating
instructions.
Note:
R If you cannot hang up the call using your
headset, press MZN on the base unit 2
times.
Switching between the base unit and
your headset
You can switch between the base unit and
your headset:
– during a landline call with the base unit
speakerphone.
– during an intercom call between the base
unit and handset.
– while listening to messages recorded on
the base unit answering system.
n To switch to your headset:
Press M N on the base unit.
n To switch to the base unit:
Press MZN on the base unit.
54 For assistance, please visit http://www.panasonic.com/help
Using Bluetooth Devices
TG78xx(en)_1210_ver101.pdf 54 2012/12/10 21:19:30