Panasonic TYFB9TU - Manual (Page 13)

13
English
Replicating the settings - CLONE BOX
The Clone Box (separately purchased) replicates the settings of the master TV into other TVs.
1
Select the settings of the master TV (see pages 9-12).
You can replicate the following settings.
2
Press [ CH , CH ] or the numbered buttons to select the initial
channel you would like to display at power ON (ex. self-advertising
channel).
3
Press [ VOL , VOL ] to select the volume level which will be
the maximum volume in the HOTEL mode (see page 14).
Be sure to set the TV to the normal TV mode before uploading. If not in the normal
TV mode, change the mode referring to “Switching between the normal TV mode
and the HOTEL mode” (see page 14).
Preparation
• Connect the master TV display to the AC outlet.
• Connect the Clone Box to the MATE terminal on the tuner board.
1
Turn the master TV display on.
2
Turn the Clone Box on.
The red and green LEDs on the Clone Box flash.
3
Hold down [ALT] button and press [LEARN] button on the Clone
Box.
• The red LED flashes during uploading.
• The green LED lights for approx. 2 seconds when uploading is completed.
• After uploading, the master will be automatically switched into the HOTEL mode.
4
Turn the main power of the display and the Clone Box off.
Selecting the master TV settings
Uploading the master TV’s settings into the Clone Box (LEARN)
POWER
ASPECT
R-TUNE
RECALL
ACTION
CH
CH
VOL VOL
INPUT TV/VIDEO
MUTE
SAP
Menu Submenu Menu Submenu
PICTURE PIC MODE AUDIO BASS
COLOR TREBLE
TINT CHANNELS PRESET CAPTION
BRIGHTNESS MANUAL CAPTION
PICTURE INPUT LABEL
SHARPNESS SET UP AUTO PROGRAM
COLOR TEMP MANUAL PROGRAM
ENERGY MGMT
1. Insert a slender tool about 3/4 inch (ex. a paper clip) into
[AMS] hole on the Clone Box to switch the TV to the normal
TV mode.
The green LED lights for approx. 2 seconds.
2. Press [TEST] button on the Clone Box.
• The red and green LED flash alternately during checking.
• The green LED lights for approx. 2 seconds when the settings
replicated in the Clone Box correspond to the master TV settings.
If the red LED does not light, upload the settings again.
1. Turn the Clone Box on.
2. Hold down [ALT] button and press [TEST]
button on the Clone Box.
• The red and green LEDs flash alternately
during checking.
• The green LED lights for approx. 2 seconds
when the battery has enough remaining
power. If the LEDs do not light, replace the
battery to new one (use a 9-volt battery).
To check the settings uploaded into the Clone Box To check the Clone Box’s battery