Panasonic TYFB9TU - Manual (Page 3)

3
English
MATE
Safety Precautions (Be sure to observe)
WARNING
• Never attempt to disassemble or modify this product.
To avoid fire, shock, or failure.
• If you sense smoke, an odd odor, or unusual noises while in operation, immediately unplug the display.
Switch off the display and unplug the power cord plug from the supply outlet.
To avoid fire or shock, do not leave the power of the display turned on.
• To avoid shock or other problems, do not leave the power cord plug plugged into the supply outlet.
Handling Cautions
• Do not touch connector contacts with hands directly.
To avoid electrostatic damage to internal parts, before handling this product touch a large metallic object such as a
steel cabinet to discharge yourself.
• Be sure to use the supplied cable or specified parts for interconnection.
To avoid malfunction or failure, do not use parts other than those recommended.
Accessories
Please check and identify the supplied accessories.
• Remote control
N2QAFB000003
• Terminal function label (1 sheet)
(Affix this label to the applicable slot of the rear
panel of the display.)
• F-type antenna adapter • Screw (
×
4)
For 5C (
×
1) For 4C (
×
1)
1. Open the cover.
2. Insert batteries. Note the correct
polarity (+ and -).
AA size
Remote Control Batteries
• Ferrite core
(
×
1)
• Terminal Board
Replacement
Instructions
• Remote control
batteries
(AA Battery
×
2)
Precautions
Mishandling of batteries can cause electrolyte leakage which can
damage items the fluid contacts and may cause a fire.
• Do not mix old and new batteries.
• Do not use different types at the same time. (ex. zinc carbon and
alkaline)
• Do not heat or expose to flame.
• Do not take apart or short circuit.
• Do not attempt to recharge, short-circuit, disassmble, heat or burn
used alkaline or manganese batteries.
• Replace the batteries if the remote control does not work properly.
For your reference
Use alkaline batteries for longer life.
• Please contact our designated service department for installation or change of this Product.
To Service personnel:
Before removing or installing the Terminal Board, be sure to turn power of the display off and unplug the
power cord plug from the supply outlet.