P297) – Panasonic DMC-GF6KK User Manual
Page 297
297
Others
[Picture is displayed for 16:9 TV]/[Picture is displayed for 4:3 TV]
•
Select [TV Aspect] in the [Setup] menu if you want to change the TV aspect.
•
This message also appears when the USB connection cable is connected to the camera only.
In this case, connect the other end of the USB connection cable to a PC or a printer.
[Editing operation cannot proceed as information processing is ongoing.]
•
When there are too many image files, the currently retrieving information icon ([
] or
[
] ) may be displayed on the playback screen for a long period of time. During this
time, deletion and use of the [Playback] menu are not possible.
•
If this unit is turned off while acquiring information, only the pictures that have already
acquired the information are saved as a group. When you switch on again, the information
retrieval will restart from the same point.
[This battery cannot be used]
•
Use a genuine Panasonic battery. If this message is displayed even when a genuine
Panasonic battery is used, contact the dealer or Panasonic.
•
If the battery terminal is dirty, clean it and remove any objects.
[Failed to connect wireless access point]/[Connection failed]/[No destination
found]
•
Check following regarding the wireless access point.
> The wireless access point information set on this unit is wrong. Check the authentication
type, encryption type, and encryption key.
> Power of the wireless access point is not turned on.
> Setting of the wireless access point is not supported by this unit.
•
Check the network setting of the destination.
•
Radio waves from other devices may block the connection to a wireless access point. Check
other devices that are connected to the wireless access point and devices that use the
2.4 GHz band.
[No picture to send]
•
This is displayed when there is no image to transmit due to the restriction of the destination.
Check the file format of the image to send.
[Connection failed. Please retry in a few minutes.]/[Network disconnected. Transfer
stopped.]
•
Radio waves from the wireless access point are getting weak. Perform the connection closer
to the wireless access point.
•
There is no reply from the server or it has exceeded the communication processing time. Try
again after a while.
•
Depending on the wireless access point, connection may be automatically disconnected after
specific time has passed. Reconnect the connection again.