Auerswald 2500 - Manual (Page 159)

Configuration of the Telephone
Display Settings
159
If you like to operate (additionally) a Voicemail Centre 461 with the telephone, let the quick
remote access switched off in order to avoid incorrect access to the device.
The Voicemail Centre 461.2 has to use at least the firmware version 2.02 for the support of
this function.
Display Settings
Configure the Display Light (only COMfortel 2500)
You can adapt the display backlight to the requirements of your work place.
The selection “on during call” or “automatically” requires the additional setting of the bright-
ness (see next chapter).
Set Brightness (only COMfortel 2500)
You can adapt the brightness of the display backlight to the requirements of your work place.
Under “brightness min.” you set the basic brightness in the idle state of the telephone.
Under “brightness max.” you set the brightness of the display in the state of ringing, during a
call as well as during the operation.
☞
Advice
Open the settings menu for the setting “display
light” (You will find help on
page 33 and the
following).
settings
display
display light
The icon marks the current
setting.
Use the and softkeys to browse to the
option you require and press the softkey to
the left of the option:
ț deactivate: Switch off the light completely.
ț on during call: Additionally to the defined
time in the selection “automatically” (see
below) the light stays active during the call
and thereafter for a short transition period.
ț automatically: As soon as a key is pressed,
the receiver is picked up or the telephone is
called, the light (maximum brightness) is
switched on and stays active for a short tran-
sition period thereafter. But the light remains
to be always active (minimum brightness).
...
☞
Advice