Agilent Technologies N9360A - Manual (Page 42)

6-8 N9360A Multi UE Tester Quick Reference Guide
6 cdma2000 System
For Troubleshooting
Figure 6-6 [Manual Test (1xEV-DO): Stand-by] Screen
1 Press the Manual Test softkey on the [Initial] screen.
2 Move the cursor to the "Procedure" field and select a
pre-defined test procedure.
3 Press the UATI Assign softkey.
4 Turn the mobile phone on, and wait for the completion of
UATI Assignment.
5 Press the BS Call softkey.
6 While "Connection" is highlighted in the test flow, press the
Trigger
softkey to start single measurement or the Trigger
Sing/Cont softkey to start continuous measurement. Press the
Trigger Sing/Cont softkey again to terminate continuous
measurement.
7 Press the Release softkey to finish the test.