Apple ATI RADEON CABLE HD 4870 User Manual

Page 3

Advertising
background image

073-1250 Rev. A

3

© 2009 Apple Inc. All rights reserved.

4

Press button on PCIe
fan.

Move fan to left,

5

which releases
retention bar.

6

Disconnect card’s
cables from
backplane board.

Holding card by top

7

corners, pull it up out
of slot and remove
card from computer.

Note: If card is held in place by retention bar, complete steps 4 and 5. Otherwise, release small
locking clip at front of card’s connector by pushing clip up. Then go to step 6.

Checklist for handling card:

When removing or installing card, handle it only by the edges. Do not touch its connectors

•

or any components.
Don’t rock card from side to side; instead, lift card straight up from connecotr to remove it,

•

and press card straight into slot to install it.
Don’t force card. If you meet a lot of resistance, pull card out. Check connector and slot for

•

damage or obstructions, then try inserting card again.
Pull card gently to see if it is properly connected. If it resists and stays in place and its gold

•

connectors are barely visible, card is connected.

Advertising