AT&T E5812B - Manual (Page 37)

34
Answering system operation
1. CLOCK.
The system will announce
the current clock setting,
then announces “To set the
clock, press
CLOCK.”
3.
SKIP or
REPEAT
until the system announces
the correct day, then press
CLOCK.
2. CLOCK.
The system will announce
the current day setting, then
announces “To change the day,
press
SKIP or REPEAT,
to change the hour, press
CLOCK.”
4.
until the system announces
the correct hour, then press
CLOCK.
until the system announc-
es the correct minute, then
press CLOCK.
5.
6.
until the system announc-
es the correct year, then
press CLOCK. The system
announces the current clock
setting.
SKIP or
REPEAT
SKIP or
REPEAT
SKIP or
REPEAT
Day & time announcements
To set day and time
Before playing each message, the answering sys-
tem announces the day and time when the mes-
sage was received.
Before using the answering system, follow the
steps on the left of this page to set the day, time
and year, so that messages are dated correctly.
If the clock is not set, before new messages are
recorded, the system will announce "Time and day
not set" before each message is played back.
The system uses voice prompts to guide you. Each
time you press SKIP or
REPEAT , the day, hour,
minute or year increases or decreases by one.
When you hear the correct setting, press CLOCK
’‹”ƒ’’†ƒŒƒ–’‘ƒ’’‡Œ Ɠ
To check day and time
You can press CLOCK at any time to hear the cur-
rent day and time without changing it.
NOTES:
1. You can press and hold SKIP or REPEAT to increase or
decrease the minutes or years by ten.
ǎƓŠŠƒ
 Ž”‡‚ƒ‘ ’†ƒ ’‡‹ƒ Œ‚ ‚’ƒƓ ƒ’ ’†ƒ —ƒ ‘ ’†’
’†ƒ ‚— „ ’†ƒ •ƒƒ‰ Œ €ƒ Š“Š’ƒ‚ „‹ ’†ƒ ŠŠƒ

information. After you set the time once, it will thereafter
€ƒ ‘ƒ’ “’‹’‡ŠŠ— •‡’† ‡Œ‹‡Œ  ŠŠƒ
 ‡Œ„‹’‡ŒƓ
The time will be set automatically only if you subscribe to
ŠŠƒ
‘ƒ”‡ƒŽ”‡‚ƒ‚€——“ŠŠ’ƒŠƒŽ†Œƒ‹ŽŒ—
(page 27).