AT&T E5812B - Manual (Page 39)

36
Answering system operation
1. SETUP
3.
SETUP
- OR -
2.
SKIP or
REPEAT
PLAY /STOP
Changing feature options
You can change how the answering system oper-
ates. Press SETUP repeatedly to hear each feature.
When you hear the feature you want to modify
press SKIP or REPEAT to change the setting.
Press
PLAY /STOP ’Œ„‡‹’†ƒ‘ƒ’’‡Œ Œ‚ƒ–‡’
the menu.
Feature options ƪƒ„“Š’‘ƒ’’‡Œ ‘“Œ‚ƒŠ‡Œƒ‚ƫ
System announces: Feature description:
"Number of rings," cur-
rent setting, then "To
change the setting press
SKIP or REPEAT; to con-
tinue setup, press
SETUP."
Ž’‡Œ‘ƒǎƤ4/6/toll saver
“Base ringer,” current set-
ting, then “To change the
setting, press
SKIP or
REPEAT; to continue setup,
press
SETUP.”
Ž’‡Œ‘ƒ†‡ †Ƥlow/off
"Remote access code,"
current setting, then "To
change the setting press
SKIP or REPEAT; to con-
tinue setup, press
SETUP."
Ž’‡Œ‘ƒ ƪ‘ƒŠƒ’  ’•ƕ
digit code) 19
"Message alert tone,"
current setting, then "To
change the setting, press
SKIP or REPEAT; to con-
tinue setup, press
SETUP."
Ž’‡Œ‘ƒŒƤoff
Choose number of rings before
the system answers a call. When
toll saver is active, the system
answers after two rings if you
have new messages, and after
four rings if you have no new
messages. When retrieving mes-
sages from a long distance call,
you may disconnect your call
after three rings so that there
will be no long distance charge
incurred.
Choose the base ringer volume
between high and low level, or
turn the base ringer off.
Select a two-digit number (10-99)
for remote access from another
telephone (page 41).
When on, the telephone beeps
every 10 seconds when there are
new messages.
NOTE: Press and hold
SKIP
or REPEAT to increase or decrease
the remote access code number by
ten.
until desired feature
is heard (see list at
right).
until desired selection
is heard.
to set selection and
move
’Œƒ–’‹ƒŒ“
option.
to set selection and
exit menu.
NOTES:
1. The message alert tone will
beep only if all the conditions
below are met:
Answering system is on
Message alert tone setting
is on
Have new messages
ǎƓ ƒ‘‘ Œ— €‘ƒ ‰ƒ— ƪƒ–ƒŽ’
HANDSET LOCATOR) to
temporarily silence the mes-
sage alert tone. If you press
and hold
DELETE you will
delete all old messages and
the message alert tone will
be temporarily silenced. The
message alert tone will be
ƒƕ’‡”’ƒ‚ •‡’† ’†ƒ Œƒ–’
incoming message.