Panasonic SC-PM200 - Manual (Page 9)

E
N
G
L
IS
H
ENGLISH
RQT9547
9
9
Sound effects
Changing the sound quality
1 Press [SOUND] to select a sound effect.
2 Within 3 seconds, press [Y, U] to select the desired
setting.
BASS
-4 to +4
TREBLE
SURROUND “ON SURROUND” or
“OFF SURROUND”
INPUT LEVEL
(For music port source) “NORMAL” or “HIGH”
By main unit only
1 Press [BASS/TREBLE] to select “BASS” or
“TREBLE”.
2 Press [2/3] or [5/6] to adjust the level.
Preset EQ
Press [PRESET EQ] to select a setting.
HEAVY Adds punch to rock
SOFT For background music
CLEAR Clarifies higher frequencies
VOCAL Adds gloss to vocal
FLAT Cancels the sound effect
D.BASS
This function lets you enjoy a powerful bass effect.
Press [D.BASS] to select “ON D.BASS” or
“OFF D.BASS”.
External equipment
Components and cables are sold separately.
Using the music port
You can play music from a portable audio equipment.
Preparation
Switch off the equalizer (if any) of the portable audio
equipment to prevent sound distortion.
Decrease the volume of the system and the portable audio
equipment before you connect or disconnect the portable
audio equipment.
1 Connect the portable audio equipment.
Plug type: Ø 3.5 mm stereo (not included)
2 Press [RADIO, EXT-IN] to select “MUSIC PORT”.
3 Play the portable audio equipment.
To adjust the audio input level (Z “Changing the
sound quality”).
Select “NORMAL” if the sound is distorted during “HIGH”
input level.
Connecting to headphones
Connect the headphones to the headphones jack.
Plug type: Ø 3.5 mm stereo (not included)
• Avoid listening for prolonged periods of time to prevent
hearing damage.
• Excessive sound pressure from earphones and
headphones can cause hearing loss.
• Listening at full volume for long periods may damage
the user’s ears. Be sure to use the supplied or
recommended headphones or earphones.
Remote control code
When other Panasonic equipment responds to the remote
control of this system, change the remote control code for
this system.
Preparation
Press [RADIO, EXT-IN] to select “MUSIC PORT”.
To set the code to “REMOTE 2”
1 Press and hold [RADIO, EXT-IN] on the main unit
and [2] on the remote control until “REMOTE 2”
is shown.
2 Press and hold [OK] and [2] for a minimum of
4 seconds.
To set the code to “REMOTE 1”
1 Press and hold [RADIO, EXT-IN] on the main unit
and [1] on the remote control until “REMOTE 1”
is shown.
2 Press and hold [OK] and [1] for a minimum of
4 seconds.
PM200_EP_1gb.indd 9 PM200_EP_1gb.indd 9 5/9/2011 5:15:50 PM 5/9/2011 5:15:50 PM