Panasonic PT-DW7700 ENG - Manual (Page 61)

61
How to use ADVANCED MENU
ADVANCED MENU
DIGITAL CINEMA REALITY AUTO
FORMAT
SMPTE
BLANKING
INPUT RESOLUTION
CLAMP POSITION
EDGE BLENDING
OFF
SYNC.TERM 75
RASTER POSITION
:MENU SELECT
:CHANGE
MAIN MENU
PICTURE
POSITION
ADVANCED MENU
LANGUAGE
OPTION
TEST PATTERN Press the “MENU” button.
The MAIN MENU screen will be displayed.
Select “ADVANCED MENU” with the
buttons.
Press “ENTER” button.
The ADVANCED MENU screen will be displayed.
Select “FORMAT” with the
buttons.
Switch the signal format with the
buttons.
• This toggles between SMPTE and BETACAM.
<Signal level>
Format
SMPTE
BETACAM
Y
700 mV
714 mV
Synchronous part
300 mV
286 mV
C b , C r
±350 mV
±504 mV
• This function is available only when input signals are supplied through the analog RGB input module
(ET-MD95RGB). RGB1, RGB2 inputs do not support BETACAM signals.
• This function can be switched only when receiving the picture of 480i in the YCbCr mode.
It cannot be switched when receiving the picture of signals other than RGB-REALITY mode, RGB
mode and 480i.
• SMPTE is the factory default.
Note
• In DIGITAL CINEMA REALITY mode, the image quality will be deteriorated if 30p FIXED or 25p FIXED
is selected when the signal is not a 2:2 pulldown signal.
Note
ADVANCED MENU
DIGITAL CINEMA REALITY AUTO
FORMAT
SMPTE
BLANKING
INPUT RESOLUTION
CLAMP POSITION
EDGE BLENDING
OFF
SYNC.TERM 75
RASTER POSITION
MAIN MENU
PICTURE
POSITION
ADVANCED MENU
LANGUAGE
OPTION
DIGITAL CINEMA REALITY
Increase the vertical resolution when the PAL (or SECAM) 576i signal input or the NTSC 480i signal input is applied.
Procedure of adjustment
FORMAT (To input BETACAM with YCbCr 480i)
When receiving a picture of 480i with analog component signal YCbCr input, the input level of Cb and Cr can be switched.
Procedure of adjustment
Press the “MENU” button.
The MAIN MENU screen will be displayed.
Select “ADVANCED MENU” with the
buttons.
Press “ENTER” button.
The ADVANCED MENU screen will be displayed.
Select “DIGITAL CINEMA REALITY”
with the
buttons.
OFF: Unforced cinema processing
AUTO: Performs automatic detection and cinema
processing. (factory default)
30p FIXED: Forced cinema processing (2:2
pulldown) is performed when a 480i
signal is input.
25p FIXED: Forced cinema processing (2:2
pulldown) is performed when a 576i
signal is input.