Panasonic WJ-NV200 - - Manual (Page 50)

50
Set up recording/events [REC & event]
The "REC & event" page has 3 tabs; the [Recording setup] tab, the [Event setup] tab and the [Advanced setup] tab.
Recording setup tab [Recording setup]
Configure the settings relating to schedule recording. Set the day(s), time table(s), frame rate and image quality for recording.
■ Schedules
Recording will be performed according to the schedules set
in advance. Select the day(s) of the week and the time
table(s).
[Days to record]
Select the day(s) of the week to record. Mark the
checkbox(es) of the day(s) of the week to record.
[Schedule to record]
3 time tables for schedule recording can be set up for "Time
table 1". The time bar indicates 24 hours in steps of 15 min-
utes.
Step 1
Click the recording start time on the time bar.
→ The start time will be displayed, and the 15-minute sec-
tion of the time bar from the start time turns red.
Step 2
Click the recording end time on the time bar.
→ The end time will be displayed, and the time bar turns
red from the start time to the end time.
Note:
• The recording time table can be set by dragging the start
and end time on the time bar with the mouse.
• Be sure to set so that there is no overlap between the 3
time tables. When attempting to set the same time as
already set on another time bar, the time immediately
before or after the overlapping time will be set.
[HDD saving mode]
Reduce the recording rate to use less storage space on the
HDD. Mark the checkbox of this item to save HDD storage
space. Using H.264/MPEG-4 as compression method in this
mode will record only refresh interval images; using MJPEG
will record at a frame rate of 1 ips. This mode can be set
separately for each time table.
[Advanced >] button
The "Advanced schedule setup" page will be displayed. In
addition to 3 schedule recordings, 3 event recordings can be
set up. (☞ Page 51)
■ Recording setup (All cameras)
Set the recording frame rate and image quality. The settings
will be applied to all cameras.
[Frame rate]
Select the recording frame rate.
1 ips/ 3 ips/ 5 ips/ 10 ips/ 15 ips/ 30 ips
Default: 10 ips
Important:
• When the compression method of the camera is
MJPEG, 10 ips, 15 ips and 30 ips are unavailable. The
default is "5 ips".
[Image quality]
Select the recording image quality.
NQ (Normal): Standard quality
FQ (Fine): High quality
SF (Super Fine): Super fine quality
Default: FQ
[Referenced recording days]
Calculates and displays the total number of days for which
recording on the hard disk drives is available.
Note:
• When the HDD saving mode is set, the actual recording
days are longer than the referenced recording days.
• The HDD consumption for the event recording will be
excluded.
• If a camera manufactured by other than Panasonic is
used, the value of "Referenced recording days" will not
be displayed.
• "*" preceding an item indicates that the item has been
changed on the "Advanced recording setup" page.
[Advanced >] button
The "Advanced recording setup" will be displayed. Each
camera can be set up separately for recording. (☞ Page 52)