Panasonic WJ-NV200 - - Manual (Page 70)

70
The version of the recorder and disk information is displayed, and the settings relating to hard disk drives can be configured on
the setup menu - the "Advanced setup" menu - the "Maintenance" page. It is also possible to initialize the setup data of the
setup pages, check the system logs and register the license on this page.
The "Maintenance" page has [System information], [HDD information] and [System management] tabs.
Check the system information such as the version [System information]
The version (of the software and hardware), serial number, network information (MAC address, IP address, line speed: the current
value (= the actual line speed)) of the recorder, temperature inside the recorder and highest temperature inside the recorder, etc.
are displayed on this tab. (Information will not be updated while the "Maintenance" page is being displayed.)
Configure the settings relating to maintenance [Maintenance]
Confirm the hard disk drive information [HDD information]
The capacity and operation time of the hard disk drives on the recorder and the time range of the images recorded on the hard
disk drives are displayed on this tab. (Information will not be updated while the "Maintenance" page is being displayed.)
[Capacity]
Displays the capacities of the hard disk drives.
[Operation]
Displays the operating time of the hard disk drives.
[Status]
Displays the statuses of the hard disk drives.
Normal: Hard disk drives that are operating normally
Playback-only: Hard disk drives for playback use only
(Recording is unavailable.)
Removed: Hard disk drives that are excluded from oper-
ation due to fault
Error: Hard disk drives that have become faulty during
the format process
Blank: No connection to hard disk drives
[Recorded time range]
Displays the time range of the images recorded on the hard
disk drives.
[Overwrite cycle]
Calculates and indicates the overwriting cycle of the hard
disk drives, based on the past recording performance (the
oldest recorded data, the current date & time and the capac-
ity of the hard disk drive).
Note:
• The hard disk drives installed in the HDD1 slot and the
HDD2 slot are displayed as "HDD1" and "HDD2" respec-
tively.