CatEye CC-RD310W [Strada Slim] - Manual (Page 4)

Adjust the sensor magnet so that the conditions of , , are satisfi ed, and
then check the operation by turning the front wheel slowly.
Positioning and testing
Max.
60 cm
(23-5/8” )
5 mm (3/16”)
STRADA SLIM CC-RD310W ENG 4 How to install the unit on your bicycle
2 Install the sensor
Install the magnet Remove/Install the computer
Install the sensor and magnet in a position where
the following conditions are satisfi ed.
The distance from the computer
to the sensor is within the trans-
mission data length, and the back
of the computer faces downward.
The magnet passes through the sensor
zone of the speed sensor.
The clearance between the sensor sur-
face and the magnet is within 5 mm.
Check the mounting position of the sensor and magnet
Get an estimate of the mount-
ing position where the clearance
between the magnet surface and
sensor zone is 5 mm or less, by
sliding up and down the sensor
and magnet before mounting.
3 4
While supporting it by hand,
Push it out as if lifting the front up
To the SENSOR ZONE
Spoke
Magnet
Inside the
front fork
or
Rubber band
Nylon tie
SENSOR ZONE
Speed sensor
(SPD-02)
Speed sensor
(SPD-02)
Magnet
Spoke
Inside the front fork
Sensor rub-
ber pad
Click
Speed sensor
(SPD-02)