CatEye CC-VL520/CC-VL820 [Velo 7/Velo 9] - Manual

VELO 9 / VELO 7 ENG 1
Before using the computer, please thoroughly read this
manual and keep it for future reference.
Warning / Caution
• Do not concentrate on the computer while riding.
Ride safely!
• Install the magnet, sensor, and bracket securely.
Check these periodically.
• If a child swallows a battery, consult a doctor immediately.
• Do not leave the computer in direct sunlight for a long period of time.
• Do not disassemble the computer.
• Do not drop the computer to avoid malfunction or damage.
• When cleaning the computer, bracket and sensor, do not use thinners,
benzene, or alcohol.
• Risk of explosion if battery is replaced by an incorrect type.
Dispose of used batteries according to local regulations.
• LCD screen may be distorted when viewed through polarized sunglass
lenses.
CATEYE
VELO 9 / VELO 7
CYCLOCOMPUTER
CC-VL820 / CC-VL520
Maintenance
• To clean the computer or accessories, use diluted neutral detergent
on a soft cloth, and wipe it off with a dry cloth.
• If the gaps between the buttons and the unit get clogged with mud or
sand, wash them away with water.
Replacing the battery
When the display becomes dim, replace the
battery. Install a new lithium battery (CR2032)
with the (+) side facing upward.
* After replacing the battery, be sure to set the
unit again according to the procedure speci-
fied in “Preparing the computer” (page 3).
Troubleshooting
No display.
Is battery in the computer run down?
Replace with new batteries according to the procedure specified
in the section “Replacing the battery”.
Incorrect data appear.
Follow the procedure described “Preparing the computer” (page 3).
Current speed does not appear.
(First, short-circuit the contact of the computer a few times with a piece
of metal. If current speed appears, the computer is working fine and the
cause should be attributed to the bracket or the sensor.)
Is the wire broken?
Even if the outside of the wire looks normal, there could be
damage. Replace the bracket sensor kit with a new one.
Is the clearance between the sensor and the magnet too large?
Are the magnet’s center and the sensor’s marking line aligned?
Re-adjust the positions of the magnet and the sensor.
(The clearance should be less than 5 mm.)
Is there anything sticking on the contact of the computer or the
bracket?
Clean the contact with a cloth.
COIN
CR2032
Close
Open
Specification
Battery / Battery life Lithium battery (CR2032) x 1 / Approx. 3 year
* The factory-loaded battery life might be shorter than the above-mentioned specification.
Controller
4 bit, 1-chip microcomputer (Crystal controlled oscillator)
Display Liquid crystal display
Sensor No contact magnetic sensor
Tire size to be
selected
26”, 700c, 27”, 16”, 18”, 20”, 22” and 24”, or tire circumference of
100 cm - 299 cm (initial value: 26 inch)
Working
temperature
32 °F - 104 °F (0 °C - 40 °C) (This product will not display appropri-
ately when exceeding the Working Temperature range. Slow response
or black LCD at lower or higher temperature may happen respectively.)
Dimensions/weight 2-3/16” x 1-15/32” x 5/32” (55.5 x 37.5 x 18.5 mm) / 1.06 oz (30 g)
* The specifications and design are subject to change without notice.
Limited warranty
2-Year: Computer only
(Accessories/Bracket sensor and Battery Consumption excluded)
CatEye cycle computers are warranted to be free of defects from materials and workmanship
for a period of two years from original purchase. If the product fails to work during normal
use, CatEye will repair or replace the defect at no charge. Service must be performed by Cat-
Eye or an authorized retailer. To return the product, pack it carefully and enclose the warranty
certificate (proof of purchase) with instruction for repair. Please write or type your name and
address clearly on the warranty certificate. Insurance, handling and transportation charges to
CatEye shall be borne by person desiring service. For UK and REPUBLIC OF IRELAND con-
sumers, please return to the place of purchase. This does not affect your statutory rights.
Please register your CatEye product on the website.
http://www.cateye.com/en/support/regist/
2-8-25, Kuwazu, Higashi Sumiyoshi-ku, Osaka 546-0041 Japan
Attn: CATEYE Customer Service Section
Phone : (06)6719-6863 Fax : (06)6719-6033
E-mail : [email protected] URL : http://www.cateye.com
[For US Customers]
CATEYE AMERICA, INC.
2825 Wilderness Place Suite 1200, Boulder CO 80301-5494 USA
Phone : 303.443.4595 Toll Free : 800.5.CATEYE
Fax : 303.473.0006 E-mail : [email protected]
Parts kit Bracket
sensor kit
Wheel
magnet
Lithium
battery
Spare accessories
Standard accessories
1603390 1603391
1603491
1665150
CR2032
1699691N
Optional accessories
Heavy duty bracket
sensor kit
In use