CatEye CC-MC200W [Micro Wireless] - Manual (Page 2)

CC-MC200W ENG 2 How to install the unit on your bicycle
SENSOR ZONE SENSOR ZONE
SENSOR ZONE
SENSOR ZONE
SENSOR ZONE
5 mm
When attaching the FlexTight™ bracket to the stem
1
Attach the bracket to the stem or handlebar
2
Install the sensor and magnet
The FlexTight™ bracket can be attached to either the stem or the handlebar, depending on how the bracket fits into the bracket band.
Caution: Be sure to tighten the dial of the FlexTight™ bracket by hand.
Tightening it strongly using a tool, etc. may damage the screw thread.
Remove/Install
the computer
Bracket
band
Sensor Sensor
rubber pad
Nylon ties
(x 2)
Magnet
Bracket band
Bracket band
Handlebar
Click
Dial
Cut
Cut
While supporting it by hand,
Push it out as if lifting
the front up
Stem
Bracket
Bracket
Bracket
Dial Bracket
rubber pad
Bracket
rubber pad
Bracket
rubber pad
Sensor rubber pad
* Install the sensor above the front fork as much as possible.
Speed
sensor
Nylon ties
Pull
securely Magnet
Spoke
Magnet
Magnet
SENSOR
ZONE Speed
sensor
Speed
sensor
Magnet
Speed
sensor
SENSOR
ZONE
To the SENSOR ZONE
When attaching the FlexTight™ bracket to the handlebar Install the sensor and magnet
The magnet passes through the
sensor zone of the speed sensor.
The distance from the com-
puter to the sensor is within
the transmission data length,
and the back of the computer
faces downward.
The clearance between the sen-
sor surface and the magnet is
within 5 mm.
Caution:
Round off the cut
edge of the bracket
band to prevent
injury.
* To mount the bracket to an aero-shaped handlebar or larger stem, use the optional nylon ties
bracket.
* The wheel magnet may be installed
anywhere on the spoke if the instal-
lation conditions are satisfied.
1
2