CatEye GB-100 [Gamebike] - Manual (Page 3)

3
How to adjust the GAMEBIKE
• Adjusting the steering sensitivity
Turn on the "Playstation2", then slide the steering
sensitivity control of the GAMEBIKE Controller while
operating the handle of the bicycle on the race
screen to adjust the steering sensitivity as required.
<Operation>
1. Press the blue (or pink) button depending on the function to be changed.
Keep pressing the SELECT button until the following steps are completed:
The LED will change from constantly lit to blinking.
While pressing the SELECT button, press the speed button (blue) or brake button (pink).
2. Press the default accelerator (or brake) button in the software currently being used.
• Revert to the original button function
The LED will change stop blinking and will be lit continuously, signifying that the function change is now complete.
(If analog mode is OFF, the LED will be off, signifying that the function change has been completed.)
• Adjusting the speed sensitivity
Turn on the "Playstation2", then slide the speed
sensitivity control of the GAMEBIKE Controller
while operating the pedal of the bicycle on the race
screen to adjust the speed sensitivity as required.
Button Function change
In the case of software with different button functions, change functions as follows:
The buttons to which functions can be assigned are green, pink, red, blue, L1, L2, R1 and R2.
ANALOG
SELECT START
STEERING LEVEL SPEED LEVEL
R L
ANALOG
SELECT START
STEERING LEVEL SPEED LEVEL
R L
Steering sensitivity
STEERING LEVEL
Min. Max.
Speed sensitivity
SPEED LEVEL
Fast Slow
Connecting the device to Playstation2
This controller is compatible with the "Playstation2". Plug the connector of this device into the controller terminal
located at the front of the "Playstation2". Consult the operating manual of the "Playstation2" unit, if necessary.
"Playstation2" unit
1P side
Controller connector
2P side To GAMEBIKE Controller
If the GAMEBIKE does not operate after connecting
it to the PlayStation2 unit, disconnect it and reconnect
it again. Important:
It is possible for two players
to play simultaneously by
connecting two GAMEBIKEs
or connecting to a general
controller. Reference:
FCC
NOTE: This equipment has been tested and found to comply with the limits for a Class B digital device, pursuant to part 15 of the
FCC Rules. These limits are designed to provide reasonable protection against harmful interference in a residential installation.
This equipment generates, uses and can radiate radio frequency energy and, if not installed and used in accordance with the
instructions, may cause harmful interference to radio communications. However, there is no guarantee that interference will not occur
in a particular installation. If this equipment does cause harmful interference to radio or television reception, which can be determined
by turning the equipment off and on, the user is encouraged to try to correct the interference by one or more of the following measures:
— Reorient or relocate the receiving antenna.
— Increase the separation between the equipment and receiver.
— Connect the equipment into an outlet on a circuit different from that to which the receiver is connected.
— Consult the dealer or an experienced radio/TV technician for help.
Depending on the software, while
moving the handlebar from Left to
Right, the steering reaction on the
game does not work.
Depending on the software,while
pedaling, the speed of the game does
not register. This will cause the game
not to move forward. Caution
Caution
E