CatEye AT-110 [Altimeter] - Manual (Page 6)

5
E
B
C
To cycle from one LOG-Book data to another, press the S/S button.
To return to the Main screen, press the Mode button in any time.
Using the Stopwatch
In the stopwatch Sub Function the Set button, the stopwatch starts/
stops. To reset it to zero, refer to the following reset operation (press the
S/S button and Mode button simultaneously). When the stopwatch
is active, the stopwatch icon blinks.
Resetting Data
Display the data function you want to reset. Then press the S/S button
and Mode button simultaneously. The data resets to zero. If the stop-
watch is still active (running), when it is reset, the stopwatch continues
counting after returning to 00:00:00.
Note: If this operation is done in the Main screen, the corrected figure of
the current altitude is reset. (Refer to page 12 - "Altitude Correction".)
Note: If you are resetting the data of highest trip altitude or lowest trip
altitude, firstly the screen shows the largest figure of its range; and then
the reset data becomes the same value as the current altitude.
Light Button
Pressing the Light button will illuminate the EL (electro- luminescent)
back-lit screen for approx. 2 seconds.
Set Button
This button is used: • to shift from one mode to another
• to start/stop the stopwatch
• to calibrate (correct) the current altitude, or to fix
the scale/clock time.
AC (All Clear) Button (on the back)
This button is used to set up the programming of the main unit after hav-
ing replaced the battery, or when irregular display occurs during use.
When this button is pressed, all displays illuminate and then only the
scale symbols appears. The scale and clock time must be set again ac-
cording to “PREPARATIONS”.
Preserving LOG-Book Data
The LOG-Book data stored in memory in each mode will not be lost even
after the AC (All Clear) button is pressed, because the data is pre-
served in EE-PROM memory. LOG-Book data is cleared when the S/
S button and the Mode button are pressed simultaneously and only
then is the displayed LOG data reset. EE-PROM calculates the data from
when the clock time of your unit passes 0:00 every day.
Power Saving Function
If no buttons are pressed for five minutes, the power saving function auto-
matically starts. To release this function, press either S/S, Mode or
Set buttons for more than 1 second. If the unit perceives an altitude
change of more than 4 meters or 10 feet, the power saving function is
turned off.
• In the power saving function:
data of altitude and temperature are still updated every 2 minutes.
• In the standard waking mode:
data of altitude is updated every second and temperature is updated
every 20 seconds.
B
C
Highest Trip Altitude Lowest Trip Altitude Sum of Ascends Sum of Descends
* The illustration shows an example of Hike mode.
AC
F
E D
E
B
C