Nieco N2500 User Manual
Page 30
30
F. BROIL CHAIN REMOVAL
1
Run chain until the master
link is near the front idler
shaft.
2
Remove the loader bracket and lift
shaft and teflon bearings up, and slide
the bearings out.
3
Unhook the master link.
Maintain proper tension on the conveyor chains to prevent jamming. Major tension adjustments are
made by removing a link or links from the chain. Broil belt tension should be checked monthly. To do
this, allow the machine to cool, then grip the idler shaft at each end and pull on it. If the shaft and
bearings move 1/2” or more, remove a link from the conveyor belt. Before beginning, notice the way
the broil chain runs through the broiler. Also, notice the direction the chain knuckles face. Be sure to
reassemble the same way.
CAUTION
To ensure proper broiler
operation be sure to
reassemble the chain with
the knuckle opening facing
away from the direction of
travel.
Nieco Corporation - Model N2500