Vaddio HE120 Operating Instructions - Manual (Page 20)

20
Preset memories
(continued)
When performing the operations using the controller
When the AW-RP655 is connected:
Up to 50 settings can be registered and called.
The [1] to [50] buttons of [TRACING/PRESET MEMORY]
correspond to the unit’s preset memories No.1 to No.50.
  Registering the settings in the preset memories
1
Set to the preset memory mode.
Press the [TR/PSET] button to turn off its lamp.
2
Set to the memory recording mode.
Press the [M.LOCK] button to turn off its lamp.
3
Display the picture to be shot on the monitor.
Operate the [PAN/TILT] lever and [ZOOM] lever to
determine the camera angle.
Adjust the focus, iris, gain and white balance if they need
to be adjusted.
4
Hold down the [MEMORY] button.
The buttons among the [1] to [50] buttons of [TRACING/
PRESET MEMORY] in which settings can be registered
now start blinking in sequence.
  Preset memory settings cannot be registered in
buttons whose lamps are off (since they contain
tracing memory settings).
5
With the [MEMORY] button still held down,
press the button of the preset memory number
in which the setting is to be registered.
  Calling the settings of the preset memories
1
Set to the preset memory mode.
Press the [TR/PSET] button to turn off its lamp.
2
Press the button among the [1] to [50] buttons
of [TRACING/PRESET MEMORY] in which the
desired setting was registered.
  Erasing preset memory settings
1
Set to the preset memory mode.
Press the [TR/PSET] button to turn off its lamp.
2
Set the memory recording mode.
Press the [M.LOCK] button to turn off its lamp.
3
Hold down the [RESET] button.
The buttons among the [1] to [50] buttons of [TRACING/
PRESET MEMORY] whose settings can be erased now
start blinking in sequence.
  The settings for the buttons whose lamps are off
cannot be erased (since they contain tracing memory
settings).
4
With the [RESET] button still held down, press
the button of the preset memory number whose
setting is to be erased.