Vaddio ProductionVIEW HD-SDI MV User Manual
Page 24
ProductionVIEW HD-SDI MV
ProductionVIEW HD-SDI MV Manual - Document Number 342-0318 Rev. B
Page 24 of 36
>Preset
Location
>Local
>6
InCam
6
Local
In “Local” mode, the ProductionVIEW HD-SDI MV stores all 12 presets internally
In “6 InCam 6 Local” mode, the presets 1 through 6 will be stored in the cameras.
Presets 7 through 12 will be stored in the ProductionVIEW HD-SDI MV.
Note: The “6 InCam 6 Local” mode allows for switching video sources when cameras are moving to preset
locations. Since Presets are stored in Camera, the system does not have to wait for position feedback before
allowing another command to be entered.
>Switching Mode
>Select
>Single
Mode
(Default)
>Dual
Mode
NOTE: See page 3 for additional information on Dual Bus mode, as well as pages 14 – 16.
>Transition Swap (Default is on)
>On
>Off
>Settle Time (Default is 20)
>Select
>01 to 90
Note:
Settle time allows the user to set up the time delay between pressing the Take button and when the
next button can be selected on the console. With a lower settle time, there is a greater chance that a
blue screen will appear on the Program output, when the video is switched quickly, and repeatedly.
In most applications this will not be an issue. In Single Bus Mode, a faster Settle Time will also create
a video roll on the Preview output, which again in most situations will not be an issue.
>FTB Time (Default is 10)
>Select
>10 to 40
Note:
FTB Time allows the user to set up a length of time that a fade to black on the Program Output will
occur. 10 is equal to 1.0 second, 11 is equal to 1.1 seconds, etc. FTB is executed on
ProductionVIEW HD-SDI MV by pressing and holding the Mix/FTB button for more than 2 seconds.
>Program Lockout (Default is on)
>Select
>On
>Off
Note:
Program Lockout prevents a user from selecting a different source on the Program bus of the
switcher.
>Genlock (Default is off)
>Select
>Off
> HD 1080p/59.94 Hz
> HD 1080p/50 Hz
> HD 1080i/59.94 Hz
>
HD
1080i/50
Hz
>
HD
720p/59.94
Hz
>
HD
720p/50
Hz
>
SD
480i
NTSC
>
SD
576i
PAL
>
HD
1080p/60Hz
>
HD
1080p/30
Hz
>
HD
1080p/25
Hz
>Save
Config
>Save
Config
Now
Note:
All changes are saved as they occur in the switcher. The Save Config allows the user to save all
parameter changes, if multiple changes have been made.