Vaddio WallVIEW CCU HD-22 and HD-30 CAT-5 - Manual (Page 11)

WallVIEW Universal CCU HD-22/30
Vaddio WallVIEW Universal CCU Cat-5 Version. Document Number 342-0645 Rev C Page 11 of 20
Step 3: Secure the Camera To the CONCEAL Wall Mount Bracket
After all cables are attached to the camera, place the camera onto the camera mount and insert the two 1/4”-20
screws into the camera through the two-screw holes in the bottom of the mount. Note: Be sure to align each side
of the camera evenly to all sides of the CONCEAL Wall Mount Bracket before final tightening of the mounting
screws.
Step 4: Install the CONCEAL Lower Cover Plate
Attach the CONCEAL lower cover plate. Slide lower cover plate from front of the mounting bracket toward the
rear of the bracket. The two (2) rear locking tabs will need to be guided into position first and will lock in place as
the lower cover plate is pushed toward the rear of the mounting bracket and the front two (2) tabs are inserted.
Step 5: Install the CONCEAL Rear Camera Cover
After successful testing of the camera, install the CONCEAL
rear camera cover on the mounting bracket with the supplied
screw (see Fig. 5 and 6).
NOTE (One more time!): Check all Cat-5 cables for continuity in advance of the final
connection. Label the Cat-5 cables. Plugging the POWER cable into the wrong RJ-45 may
cause damage to the camera system and void the warranty.
Step 6: Connect System Power
Connect the Vaddio 36 VDC power supply to the Quick-Connect Universal CCU Interface and an AC outlet. The
CCU will power the camera via the Cat-5 cable. The camera will “Home” to a centered position ready for control
information from the Universal CCU. To ensure proper continuity of control and operation of the cameras, the
RS-232 controller (control system or joystick) should be powered on after the camera(s).
CONCEAL Lower Cover Plate
with Locking Tabs
CONCEAL Lower Cover
Plate locked in place
CONCEAL Rear Camera Cover
Completed CONCEAL Wall Mount
Camera Bracket Installation