Vaddio WallVIEW CCU HD-22 and HD-30 CAT-5 - Manual (Page 7)

WallVIEW Universal CCU HD-22/30
Vaddio WallVIEW Universal CCU Cat-5 Version. Document Number 342-0645 Rev C Page 7 of 20
Image: Rear Panel Connection and Controls (left to right)
 Power Supply Input: The Universal CCU uses a 36VDC, 2.78 Amp power supply on a 5.5mm OD x 2.5mm
ID coaxial connector.
 36 VDC to Camera - RED RJ-45: Power is provided on a Cat-5 cable to EZIM (EZCamera Interface
Module) Slot Card. The power is regulated in the camera to 12 VDC
 RS-232 IN -
GREEN RJ-45: RS-232 Input from ProductionVIEW™ console, Precision Camera Controller or
other PTZ controller. Daisy Chain control is not supported.
 RS-232 to Camera -
BLUE RJ-45: RS-232 over Cat-5 provides control signals to the camera.
 Tally on 2-pin Molex 5.0mm Euro-Style connector: A contact closure lights the blue LED on front panel
showing which Universal CCU and camera combination is the live Program in a multi-camera CCU
installation. A tally command will also be sent to the camera via RS-232 to illuminate the LED on the cameras
that have on-board tally lights.
 Camera Feature Switches: The CCU interface has an 8-position dip switch on the rear panel to allow for
certain functionality. All switches should be in the down position for default.
Dip Switch 1: Put up to allow Scene A to load upon start-up or boot up.
Dip Switch 5: Put up to access LCD Display Menu settings including Display Mode, Bias, Contrast and
Version menus.
 Video from Camera - YELLOW RJ-45: The yellow RJ-45 receives the camera’s four (4) differential video
signals from the EZIM Slot Card to the Quick-Connect CCU on Video Cat-5 cable.
 HD Video Outputs: The Universal CCU has 3 (three) simultaneous video output formats that are the same
resolution as the video inputs providing the ultimate in connectivity flexibility. The output formats include:
 HD YPbPr on DE-15-F (HD15) - (supports up to/and including 1080p/60 - not limited at 1080i/59.94)
 HDMI on HDMI-F (supports up to and including 1080p/60)
 HD-SDI on Edge Mount Carrier Class, Gold BNC-F (supports 3Gb/s Single Link 1080p/60 HD-SDI)
Note: The Quick Connect Universal CCU interface easily supports all the output resolutions of the HD-
22 and HD-30 HD PTZ cameras.
The EZIM (EZ Interface Module) HD-Series Slot Card
The EZIM Slot Card fits into the slot into the base of each of the HD-22 and HD-30 HD PTZ cameras and
terminates the Power (red) Cat-5 cable and the Video (yellow) Cat-5 cable to the camera (see colors above).
Please remove power from the camera prior to inserting, seating and screwing down the card with the attached
thumb screws. Hot swapping is generally advised, so please…turn the camera off before inserting the slot Card.
Image: EZIM Slot Card
EZIM CCU Slot Card (Front and ISO Views)