Vaddio WallVIEW CCU HD-22 and HD-30 CAT-5 - Manual (Page 12)

WallVIEW Universal CCU HD-22/30
Vaddio WallVIEW Universal CCU Cat-5 Version. Document Number 342-0645 Rev C Page 12 of 20
Drawing: Basic System Connectivity
Wiring Diagram Example:
System Configuration Notes:
The Quick-Connect Universal CCU System uses a full Cat-5 (all 4-pairs) for POWER to ensure the motors of the camera receive the required current to operate
properly. The VIDEO Cat-5 cable uses all four pairs for video. The RS-232 Cat-5 provides communication to the camera for CCU and PTZ control. These Cat.-5
cables can be run up to 500’ (152.4m). See Appendix 1 for wiring and pin-out information. NOTE: Daisy-Chain configurations are not supported.
Rear Panel of HD-22 with EZIM
CCU Slot Card installed in the
bottom row slot. All Universal CCU
camera packages are shipped with
the EZIM CCU Slot Card.
Please see the manuals for each of
the cameras for specifics regarding
set-up and switch settings.
EZIM Slot Card
VIDEO
RS-232
POWER
Three Cat-5 Cables up to 500’
between CCU and Camera
YPbPr 1080i/59.94
HDMI 1080i/59.94
HD-SDI 1080i/59.94
All 3 Video Outputs
are Simultaneous
Quick-Connect
Universal CCU
Multi-viewer Output
Simulated Video Feeds
Program Output
Simulated Video Feed
PowerVIEW
HD-22 or HD-30