Vaddio WallVIEW CCU HD-22 and HD-30 CAT-5 - Manual (Page 14)

WallVIEW Universal CCU HD-22/30
Vaddio WallVIEW Universal CCU Cat-5 Version. Document Number 342-0645 Rev C Page 14 of 20
General Specifications
 Universal CCU Interface
Connectors  Power Connector: 5.5mm OD x 2.5mm ID
 Power RJ-45: Supplies 36V to EZIM Slot Card
 RS-232 IN RJ-45: Accepts RS-232 from ProductionVIEW or other non-daisy-
chain control systems
 RS-232 OUT RJ-45: Passes RS-232 and Sync video feed to camera EZIM
 Tally: 2-Pin Phoenix type spring cage connector
 Video From Camera RJ-45: Accept differential video from EZIM Slot Card
Video Outputs:
 HD-YPbPr on DE-15-F connector
 HDMI on HDMI-F connector
 HD-SDI on Edge Mount Carrier Class, Gold BNC-F (supports 3Gb/s Single Link
1080p/60 HD-SDI)
Camera Settings
Switch All switches should be in the down position for default.
 Dip Switch 1: Put up to allow Scene A to load upon start-up or boot up.
 Dip Switch 5: Put up to access LCD Display Menu settings including Display
Mode (Negative Mode-Default or Positive Mode), Bias (Brightness) and Contrast.
 Dip Switches 2, 3, 4, 6, 7 & 8: NA for HD-22 anHD-30
Video Adjustments Y-Gain (+/- up to 10 IRE luminance gain) for fine tuning over longer cable distances
Skew for cabling distance compensation:
Cat-5 Cable
Maximum Distance Up to 500’ (152.4m)
Power Supply 36 VDC, 2.78 Amp
Dimensions 1-RU Rack Mount - 1.72” H x 18.93” W x 7” D (43.7mm x 480.1mm x 177.8mm)
Rack Ears Included
Note: Specifications and pricing are subject to change without prior notice or obligation.
 EZIM (EZCamera Interface Module) Slot Card
Connectors Two (2) RJ-45 Connectors
For Power Input and HSDS Video Out
Moon in Front Page Header: Uranus’ largest moon Titania