Vaddio WallVIEW PRO H900 - Manual (Page 10)

Quick-Connect PRO for the BRC-H900 Camera
© 2013 Vaddio - All Rights Reserved. Document Number 342-0506 Rev A Page 10 of 16
Completing the Installation:
Connect the Vaddio 36 VDC power supply to the DC Plug on the back of the Quick-Connect and the AC side to
an AC outlet. Power will travel down the Power Cat-5 cable to the EZIM, powering the camera. The camera will
“Home” to a centered position ready for control information from the IR remote control or RS-232 camera
controller of the integrators’ choice. To insure proper continuity of control and operation of the cameras, the RS-
232 controller (control system or joystick) must be powered on after the camera. Move the camera with the
camera controller and test the video functionality.
Optimizing System Performance:
Optimizing the settings will help achieve maximum performance from the system.
Adjust the Y Gain Settings:
Make sure the distance adjustment is set at its lowest setting. Adjust the trim pot
on the back of the Quick-Connect counter-clockwise until the picture fades or drops out (cable length dependent).
Adjust clockwise just past the setting where picture is restored. Leave the distance adjustment** at its lowest
setting unless recommended by Vaddio technical support.
Sony Manual:
Follow the instruction manual supplied with the BRC-H900 to set up the camera. The Quick-Connect PRO is
configured to work with the camera delivering component HD video.
General Specifications
WallVIEW PRO H900 System (Please see specs for Sony camera in the Sony manual)
Part Numbers 998-6895-000: Quick-Connect PRO H900 - North America
998-6895-001: Quick-Connect PRO H900 - International
Quick-Connect Interface
Connectors Power Connector: 5.5mm OD x 2.5mm ID
Power RJ-45: Supplies 36V to EZIM (EZCamera Interface Module) Regulators
IR: 2-Pin Molex 5.0mm Euro-Style Connector
Video Outputs: BNC Connectors for HD Analog Component (Y,PB,PR) or Y/C and Composite
Video RJ-45: Transports HD or SD video from camera depending on Break-out cable. This system
ships with HD cable only, the SD cable is an optional accessory.
Camera Select
Switch 8-Position DIP switch loads camera profiles and IR Forwarding for Polycom and TANDBERG
Codecs (IR Forwarding not supported with H900)
Video
Adjustments Y-Gain (luminance gain) for fine tuning over longer cable distances.
Distance Compensation: 100’, 200’, 300’, 400’+
Max. Cat- 5 Cable
Distance Up to 500’ (152.4m) for Video Power and Control
Power Supply 36 VDC, 2.78 Amp
Dimensions 1-RU Rack Mount, 1.72” (43.69mm) H x 18.93” (480.82mm) W x 6” (152.4mm) D
EZCamera Interface Module (EZIM)
Connectors Four (4) RJ-45 Connectors (Power, VIDEO, RS-232 IN and RS-232 OUT for Daisy-chain Control)
One DB-25 to Camera’s native connectors (Power, Video, Control)
Cable Assemblies HD Cameras: DB-25M to DE-15HD, EIAJ-04 Power Connector, 8-Pin Mini Din RS-232 IN, 8-Pin
Mini Din RS-232 OUT)
Power Regulator Internal regulator supplies 12VDC to Cameras
Dimensions 3.035” (76.2mm) H x 4.45” (113.03mm) W x 1.25” (31.75) D