Vaddio WallVIEW PRO H900 - Manual (Page 8)

Quick-Connect PRO for the BRC-H900 Camera
© 2013 Vaddio - All Rights Reserved. Document Number 342-0506 Rev A Page 8 of 16
Step By Step Mounting Instructions:
Step 1:
After determining the optimum location of the camera system, mark the locations for the four screw holes and
cable pass-thru (vertical oval). Install the drywall mounts and cut the hole for the cable pass-thru. At this point,
do not install the Wall Mount.
Image: Huge-Heavy Duty Wall Mount
The wall mount may be mounted directly to a 3-gang wall box or to drywall
with the appropriate wall anchors.
Step 2:
Connect the break out cable to the EZIM. Mount the EZIM and break out cable in the back of the wall mount,
using the supplied #6 screws and two tapped screw holes.
Image: EZIM Break out Cable and Wall Mount
Wall mount shown with EZIM CCU and HD break out cable attached to the
back of the mount with the supplied screws.
Drawing: High Definition Video & Power Break Out Cable
P/N: 440-6704-000
DB-25-M
plugs into
EZIM
12 VDC Power
on EIAJ-04
RS-232 IN
8-pin Mini Din-M
YPbPr on
DE-15-M
RS-232 Out
8-pin Mini Din-M
For daisy-chain
EZIM to EZIM
YPbPr on DE-15-M
Power on EIAJ-04 Plug
EZIM with DB-25-M of the
Breakout cable attached
RS-232 IN, 8-pin Mini Din-M
RS-232 OUT, 8-pin Mini Din-M