Vaddio WallVIEW PRO H900 - Manual (Page 9)

Quick-Connect PRO for the BRC-H900 Camera
© 2013 Vaddio - All Rights Reserved. Document Number 342-0506 Rev A Page 9 of 16
Step 3: Take the Wall Mount, with the EZIM and break out cable installed, and place it against the drywall
anchors or 3-gang wall box, making sure to pull the three Cat-5 cables through the oval pass-through hole.
Finger-tighten the screws to the mount and confirm that the base is level. Tighten the screws firmly. If the
bracket is to be mounted on a 3-gang wall box, use the screws supplied with the electrical box.
Step 4:
Three (3) Cat-5 cables are required to connect the BRC-H900 camera. Confirm that the Cat-5 cables
are terminated correctly, by testing them with a continuity tester. Connect the Power, Video and RS-232 IN Cat-5
cables from the head-end to the appropriate RJ-45 connectors on the EZIM. Connect the break-out cable to the
appropriate ports on the BRC-H900; YPbPr, RS-232 IN and Power. A 4
th Cat-5 will have to be run from the RS-
232 OUT to the next EZIM/H900 RS-232 IN to run daisy-chain control. Daisy chaining is not generally
recommended, but the world isn’t always perfect. Push the camera into place and dress the cables. Secure the
camera to the mount and using the supplied ¼”-20 screws.
Step 5:
The Quick-Connect PRO Series Interface breaks-out the signals from the Cat-5 cables back to standard
connectors at the head-end. Plug the YPbPr from the Quick-Connect PRO to the Mixer/Switcher/Controller (i.e.
ProductionVIEW HD MV with built-in Multi-viewer). There is one (1) RJ-45 to DE-9 (DB-9 for the shell size
challenged) adapter included to convert the control signals (other than Vaddio controllers) to Cat-5 cables for
attaching control systems to the camera.
Drawing: Wiring Diagram of Basic Connectivity (the basic idea)
The Quick-Connect PRO Interface uses a Cat-5 (all 4-pairs) for power to ensure the motors receive the required current to
operate properly. The Video Cat-5 cable uses three pairs for video YPbPr. The RS-232 Cat-5 is routed to the EZIM and adapted
to 8-pin Mini Din through the break-out cable. These Cat-5 cables can be run up to 500’ (152.4m). See Appendix 1 for wiring and
pin-out information.
HD-YPbPr
POWER
RS-232 IN
RS-232 OUT
If daisy-chained
Sony BRC-H900
On Heavy Duty Mount
Multi-Viewer Preview Monitor
Program Monitor
Simulated Video Feed
36VDC Power
Supply
Quick-Connect PRO
Series Interface
Rear Panel
Cat-5 Cables
up to 500’
(152.4m)
RS-232
HD Break-out
Cable
EZIM
Top Panel
EZIM, break-out cables
are dressed and put
behind camera
Power on
4-pair
HSDS
Video
Returned
HD-YPbPr
Video
ProductionVIEW HD MV
with Built-in Multi-viewer
HD
1080p/60
HD Video
RS-232 OUT Cat-5 to next EZIM RS-232 IN
If daisy-chain control is used