Fagor CFB-90AX User Manual

Page 11

Advertising
background image

11

Description of the hood

Fig. 1
1.
Control panel
2. Grease filter
3. Grease filter release handle
4. Halogen lamp
5. Vapour catcher
6. Telescopic chimney
7. Air outlet (used for filter version only)
8. Sensors

Operation

Use the high suction speed in cases of concentrated kitchen
vapours. It is recommended that the cooker hood suction is
switched on for 5 minutes prior to cooking and to leave in
operation during cooking and for another 15 minutes
approximately after terminating cooking.

Control panel

To select the functions of the hood just touch the commands.

T1. ON/OFF engine
By pressing the push-button the cooker hood is started at

speed 1.

By pressing the push-button during working the cooker hood

passes to OFF mode.


T2. Light button
Light ON/OFF button.

T3. "-" Speed decrease key
Press the key to reduce the speed of the motor.

D. Display
Indicates the status of the hood.

T4. “+” Increase motor speed
The speed sequence is 1-2-3-4, therefore every time the
“+” button is pressed the motor moves on to the next
speed level.
If the motor is at the 4th speed level and the “+” button is

pressed, you will hear a beep.

The 4th motor speed level is the intensive function and is
timer-operated.
The standard period of time is 5’, at the end of which the
hood reverts to speed level 2.
To deactivate the function before the set time has elapsed,
simply press the “-” button.

T5. Timer button
The timer value can be increased or decreased in steps of 1
minute; the default time period is set to 10 minutes.

The value can be set to a time period of anywhere between 60
minutes and 1 minute.
Within 5 seconds of the “TIMER” button being pressed, the
system will enter its programming mode and the user will be
able to set the timer countdown period using the "-" and "+"
buttons. If none of the buttons are pressed within a period of 5
seconds from when the Timer function was selected or the
time period programmed, the countdown will begin.
The timer countdown can be activated as follows:
- after pressing the TIMER button for the first time
(default time value);
- by pressing the TIMER button within 5 seconds of
setting the desired countdown time period.
Once the timer has begun counting down, it may be cancelled
by pressing the TIMER button.

T6. "S" Sensor key
Automatic function (COOKING)
The system is set by default in manual mode, to activate
automatic mode press key "S".
During cooking the system reacts promptly to increases in
Steam and remains in the speed established for at least a
minute before returning to the lower speed/switches off.
When cooking is finished and the environmental parameters
have returned to the levels preceding cooking, the system
turns itself off.
The system turns the hood off after 30 minutes if the
parameters are close to the stand-by condition.
It is possible to disable the automatic working mode as
follows:
- By pressing the "S" key, the motor goes off.
- By pressing the "+" and "-" key, the system decreases or
increases, if possible, the speed of the motor.

Selecting the hob
This operation optimizes the automatic working of the hood,
proceed as follows:
Set the hood to OFF
Press the "+" key for about 5 seconds until the hob being
currently used is displayed.
"gas": Gas hob
"ind": Induction hob
"elt": Electric hob

The hob is selected cyclically by pressing key "+"
Once the hob has been selected, wait for 10” to accept the
function.
The acceptance of the hob selected is displayed by the
sequence of 3 flashing cycles of the symbol related to the hob
selected.
The set default hob is the Gas hob.

Advertising