Fagor PRACTICA - Manual (Page 21)

19
• To change the closing seal.
• Normally the closing seal lasts for
approximately 1 year.
• The seal needs to be changed when it has
a damp, sticky appearance which it makes
it difficult to close the lid correctly.
Proceed as follows:
• Remove the used seal and carefully clean
its housing groove.
• Wet the new seal for a few seconds in tepid,
soapy water.
• Put the new closing seal into the housing
groove in the lid and press in hard making
sure that is correctly fitted.
• Finish fitting the rest of the rubber using a
blunt object
IMPORTANT NOTE
• Do not make changes in the parts, nor try
to assemble them other than in the way
indicated.
• ALWAYS USE ORIGINAL SPARE PARTS.