NaceCare Solutions NR20 - Manual (Page 11)

9
ON COMPLETION OF THE WORK
DISASSEMBLY OF BRUSH/PAD DRIVER
During storage, the machine must never rest on the
brush or on the pad. The machine weight could
permanently damage them.
To remove the brush, tilt the machine backwards, With
your thumb push down on the safety switch and then pull
on the motor levers with short impulses until the pad
driver/brush drops off of the machine.
WARNING:
DISCONNECT POWER SOURCE BEFORE PERFORMING
MAINTENANCE ON THE MACHINE
WARNING:
IF REMOVING THE BRUSH MANUALLY, MAKE SURE
THE POWER SOURCE IS DISCONNECTED.
DAILY MAINTENANCE
Before storing the machine:
• Examine the power cable for any damage. After
disconnecting the water hose from the inlet
attachment, rinse the tank with warm water to
clean it out. Re-install the tank back on to the
machine after it is cleaned out.
• clean the machine with a damp cloth.
• Inspect the brush/pad to determine if it needs to be
replaced.