NaceCare Solutions NR20 - Manual (Page 12)

10
TROUBLE SHOOTING GUIDE
INSUFFICIENT WATER ON THE BRUSH
Check that the solution valve on the bottom of the tank
has no debris in it. Also check the solution hose for debris
as well.
THE MACHINE DOES NOT CLEAN EFFICIENTLY
Check that the brush/pad is not worn.
The brush should be changed when the bristles reach
approx. 15mm long.
THE MACHINE STOPS WHILE WORKING
Check that the circuit breaker on the rear of the handle
has not tripped.
If the circuit breaker trips repeatedly, contact you nearest
NaceCare Solutions service centre.
THE MACHINE VIBRATES AND SWINGS
If the machine has been stored in the upright position
with the pad/brush on it, the pad/brush may have been
deformed by the weight of the machine. Replace the
pad/brush to correct this problem.