NaceCare Solutions NR20 - Manual (Page 8)

6
MACHINE PREPARATION
The machine must be perfectly horizontal, and vertical on
the pad driver/brush.
Move the handle from left to right until the chuck drops in
to the pad driver/brush.
With the safety switch pressed down (B). Activate the
motor using the two levers (C) until the chuck and the pad
driver/brush are locked securely in place.
WARNING
During use, By gently pressing down on the handle,
the machine shifts towards left. Lifting the handle
gently, the machine shifts towards right.
WARNING:
While assembling the brush automatically, be sure
that there is no one close to the base of the
machine.
WARNING:
Use only brushes and pad drivers delivered with the
machine or recommended by NaceCare Solutions.
The use of different products may compromise
safety.
WARNING:
The brushes with PPL or NYLON bristles and
abrasive discs must only be used for cleaning with
water and chemicals on hard floors.