NaceCare Solutions TTB516 - Manual (Page 11)

233969 / 01/13 (A20)
11
Machine Set-Up
Control of Substances Hazardous to Health (COSHH)
For best results use a non-foaming type of chemical, dilute to the manufacturers specification.
For further guidance on hazardous substances refer to health and safety instructions online.
Visit
http://www.hse.gov.uk/ for UK information.
Water Flow Adjustment
Located on the left of the machine is the On / Off water tap
(Fig 14).
Ideally set the tap to 45 0 this enables the cleaning
solution to last the same time as a fully-charged battery
(Fig 15).
Pre-cleaning advice.
Important
Do not operate machine unless the Operator Manual has been read and fully understood.
! !
Before performing the cleaning operation, place out
appropriate warning signs and sweep or dust-mop the floor
(Fig 16).
WHEN HANdlING ANd MIxING CHEMICAlS.
Always ensure that chemical manufacturers safety guidelines are followed.
Only use chemicals recommended for use in auto scrubber-driers.
! !
Fig 14
Fig 15
Fig 16
Numatic part (629044) Wet Floor sign
(available if required)
45 0