NaceCare Solutions TTB516 - Manual (Page 14)

233969 / 01/13 (A20)
14
Setting the cleaning controls
To start: hold down either trigger and press the yellow start
button once (Fig 26).
Whilst the brush motor is running press the tap On / OFF
button for fluid control (Fig 27a), the clean tank tap must be
open.
Ideally set the tap to 45
0 (Fig 27) this enables the cleaning
solution to last the same time as a fully-charged battery .
When the triggers are released the brush motor and the
cleaning solution pump will switch off, the vacuum motor will
continue for 10 seconds.
Press the cycle button to operate the brush only
(Fig 27b).
The start sequence is required in this mode.
The tap button will operate in this mode.
Press the cycle button again to get vacuum only.
The start button and triggers are not required in this mode.
(Fig 27c).
Press the cycle button to switch this mode off and return to
default mode.
The panel if unused will automatically turn off after 60
seconds.
To activate the control panel: press the cycle button or press a trigger (Fig 26).
brush overload.
The brush LED light will flash if the brush motor has been
overloaded (Fig 27d).
Releasing the handle triggers will allow the machine to stop
and reset.
If the brush motor keeps overloading
consider using a different type of brush.
Heavy brush load decreases the available battery run
time.
Fig 26
Fig 27
1 1
(Fig 27a)
(Fig 27b)
(Fig 27c)
(Fig 27d)
45 0