NOVUS TagTemp-USB - Manual

NOVUS AUTOMATION 1/5
TagTemp-USB
TEMPERATURE LOGGER – INSTRUCTIONS V 1.0x A
1 INTRODUCTION
TagTemp-USB is a small portable electronic temperature logger. Its
internal sensor measures local environment temperature and logs
such values in an electronic memory. Logged data, or
ACQUISITIONS, can be later viewed and analyzed on a PC where
they can be opened in tabular and graph forms.
The LogChart II software enables to set up the equipment operation
mode. It is also used for viewing acquisitions. Other parameters such
as end of measurements, logging interval, etc., are easily defined
through the LogChart II software.
Acquisitions can also be exported to be analyzed in other
applications, such as spreadsheet programs.
1.1 IDENTIFICATION
The identification label is on the equipment body. Check if the
features described are in accordance with your order.
Fig. 01 – Front view of the device
Status indicator: This visual indicator reports the status of operation
of equipment through the number of flashes that occur in an interval
of five seconds. The states of operation are:
• One flash: The device is waiting to start the log in memory
(standby) or completed a series of logs in memory;
• Two flashes: the device is performing logs in memory;
• Three flashes: the device is or has gone through an alarm
condition and is not performing logs in memory;
• Four flashes: the device is or has gone through an alarm
condition and is performing logs in memory.
2 TECHNICAL DATA
Measure Range Temperature: –20.0 °C to 70.0 °C.
Accuracy
± 0.1 °C @ 25 ºC.
± 1 °C max. along the entire measured range.
Note: A measure error can be fixed using the
OFFSET parameter in the LogChart II software.
Measurement
Resolutions
Temperature: 0.1 °C.
Memory capacity 32.000 (32 k) logs.
Measurement Interval
5 seconds min.
18 hours max.
Supply 3.0 V lithium battery (CR2032), built-in
Estimated autonomy
• More than 400 days – Sampling rate of 1
minute.
• More than 500 days – Sampling rate of 30
minutes.
Operating temperature From -20 °C to 70 °C
Case PC-ABS
Protection
Product suitable for applications requiring up to
IP67 degree of protection. See item "Special
Care".
Dimensions 55 x 37,5 x 15 mm
Equipment -PC data
transfer time
Proportional to the number of records. 20
seconds to 32,000 records.
PC Interface Micro-USB cable
LogChart ll software
operation environment
Configurator software for Windows ® 8, 7 and
XP.
Menus in Portuguese, English or Spanish.
Sets up, reads and displays data on the
screen.
3 OPERATION
It is only possible to operate the equipment after the LogChart II
software is installed to a PC, according to the steps described in
LogChart II Software section of this manual. The communication
between equipment and PC is performed with the aid of the micro-
USB cable.
The equipment operation mode set up is defined in advance by using
the LogChart II software. Each setting must be defined and the
consequences observed.
The equipment starts and stops logging as defined in settings.